Brake System (Other)

Reassembly

~2min read
010203040507.56N·mlb·ft
Tightening torque found on this page

REASSEMBLY

PROCEDURE

1. INSTALL VACUUM PUMP VANE

(a) Apply engine oil to the vacuum pump vane and the 2 vacuum pump vane plugs.

(b) Install the vacuum pump vane plug to the vacuum pump vane.

NOTICE:

When reusing the vacuum pump vane and vacuum pump vane plugs, install them in their original positions.

*1

Vacuum pump vane plug

*2

Vacuum pump vane

(c) Apply engine oil to the vacuum pump vane with the vacuum pump vane plugs, and install it to the vacuum pump housing.

Engine oil

NOTICE:

When reusing the vacuum pump vane and vacuum pump vane plugs, install them in their original positions and orientation.

2. INSTALL END COVER

(a) Install a new No. 1 O-ring to the vacuum pump housing.

NOTICE:

  • Remove all oil from the mating surface of the end cover and the end cover.
  • Make sure that no foreign matter is on the No. 1 O-ring or inside the vacuum pump housing.

*1

No. 1 O-ring

(b) Using a TORX T25 socket wrench, install the end cover with 5 new screws.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

NOTICE:

  • Hold the vacuum pump assembly so that its mating surface, other parts and the oil pipe are not damaged.
  • As the vacuum pump housing deforms when force is applied, do not hold it with a tool such as a vise.
  • Using the TORX T25 socket wrench, tighten the screws properly.

(c) Turn the clutch clockwise as shown in the illustration, and check that the clutch is not stuck and there is no abnormal resistance.