Brake System (Other)

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts removal, installation, or replacement during vacuum pump assembly removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Required Procedure

Effect/Inoperative function when procedure not performed

Link

Disconnect the cable from the negative (-) battery terminal.

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Initialize Back Door Lock

Door Lock Control System

PROCEDURE

1. REMOVE BATTERY

Click here

2. REMOVE NO. 2 CYLINDER HEAD COVER

Click here

3. DISCONNECT ENGINE WIRE

Click here

4. REMOVE VACUUM PUMP ASSEMBLY

(a) Slide the clip and disconnect the hose connecting the fitting to the connector pipe of the vacuum pump assembly.

(b) Remove the 3 bolts and the vacuum pump assembly from the engine assembly.

(c) Remove the No. 2 and No. 3 O-rings from the vacuum pump assembly.

*1

No. 2 O-ring

*2

No. 3 O-ring