Inspection On Vehicle
INSPECTION ON VEHICLE
PROCEDURE
1. INSPECT OPERATION
(a) Slide the clip and disconnect the hose connecting the fitting to the connector pipe of the vacuum pump assembly.
(b) Connect a vacuum gauge hose to the vacuum pump assembly. |
|
(c) Start the engine and warm it up for more than 2 minutes.
(d) With the engine idling, measure the negative pressure of the vacuum pump assembly.
Standard Pressure:
Above 86.7 kPa (650 mmHg, 25.6 in.Hg)
If the pressure is lower than the standard value, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.
Click here![]()
HINT:
Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.
(e) Remove the vacuum gauge from the vacuum pump assembly.
(f) Connect the hose connecting the fitting to the connector to the vacuum pump assembly, and slide the clip to secure it.
