Brake System (Other)

Inspection

~2min read

INSPECTION

PROCEDURE

1. INSPECT VACUUM PUMP VANE

(a) Check that the vacuum pump vane or vacuum pump vane plugs are not damaged or excessively worn.

HINT:

If the vacuum pump vane or vacuum pump vane plugs are damaged or excessively worn, replace the damaged parts with new ones.

*1

Vacuum pump vane plug

*2

Vacuum pump vane

(b) Using a micrometer, measure the length (A) of the vacuum pump vane with the vacuum pump vane plugs removed.

Minimum length (A):

23.8 mm (0.937 in.)

NOTICE:

Measure length (A) 10 mm (0.394 in.) from each end of the vacuum pump vane.

HINT:

If the length is not as specified, replace the vacuum pump vane and vacuum pump vane plugs with new ones.

*a

10 mm (0.394 in.)

(c) Using a vernier caliper, measure the length (B) of the vacuum pump vane with the vacuum pump vane plugs installed.

Minimum length (B):

76 mm (2.99 in.)

NOTICE:

Measure length (B) 5 mm (0.197 in.) from each end of the vacuum pump vane plug.

HINT:

If the length is not as specified, replace the vacuum pump vane and vacuum pump vane plugs with new ones.

*1

Vacuum pump vane

*2

Vacuum pump vane plug

*a

5 mm (0.197 in.)

2. INSPECT VACUUM PUMP HOUSING

(a) Check that the rotor part, connection, vacuum pump housing and end cover are not excessively damaged or worn.

HINT:

If the rotor part, connection, vacuum pump housing or end cover is excessively damaged or worn, replace the vacuum pump assembly.