Brake System (Other)

Installation

~2min read
010203040502115N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL VACUUM PUMP ASSEMBLY

(a) When installing a new vacuum pump assembly:

(1) Apply engine oil to the No. 2 O-ring and No. 3 O-ring installed on the vacuum pump assembly.

*1

No. 2 O-ring

*2

No. 3 O-ring

(b) When reusing the vacuum pump assembly:

(1) Apply engine oil to new No. 2 and No. 3 O-rings and install them on the vacuum pump assembly.

*1

No. 2 O-ring

*2

No. 3 O-ring

(c) Apply engine oil to the inner surface of the installation hole.

*a

Protrusion

*b

Groove

Engine oil

(d) Install the vacuum pump assembly so that the protrusion on the vacuum pump assembly engages with the groove on the camshaft.

NOTICE:

Make sure that the vacuum pump assembly is installed correctly.

(e) Install the 3 bolts.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

NOTICE:

After tightening the bolts, make sure that the contact surface of the vacuum pump assembly is level with the cylinder head.

Bolt length

Bolt A

25 mm (0.984 in)

Bolt B

45 mm (1.77 in.)

(f) Connect the hose connecting the fitting to the connector to the vacuum pump assembly, and slide the clip to secure it.

2. CONNECT HOSE CONNECTING CONNECTOR TO PIPE

(a) Connect the hose connecting the connector to the vacuum pump assembly, and slide the clamp to secure it.

3. CONNECT ENGINE WIRE

Click here

4. INSTALL NO. 2 CYLINDER HEAD COVER

Click here

5. INSTALL BATTERY

Click here

6. CHECK OPERATION

Click here