Exterior Panels / Trim
Removal
In this manual: Exterior Panels / Trim
~1min read
REMOVAL
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. REMOVE QUARTER PILLAR GARNISH SUB-ASSEMBLY
HINT:
When removing the quarter pillar garnish sub-assembly, heat the vehicle body and the quarter pillar garnish sub-assembly using a heat lamp.
Heating TemperatureItem | Temperature |
|---|---|
Quarter Pillar Garnish Sub-assembly |
20 à 30 °C |
CAUTION:
- Do not touch heated parts or the heat lamp. Touching them may cause burns.
- Prolonged contact with heated parts may cause burns.
*a |
Hot Surface |
*b |
Heat Lamp |
NOTICE:
Do not overheat the vehicle body or the quarter pillar garnish sub-assembly.
(a) Using a heat lamp, heat the quarter pillar garnish sub-assembly.
(b) Release the clips and the guide to remove the rear door opening trim cover sub-assembly, as shown in the illustration.
*a |
Double-sided adhesive tape |
![]() |
Remove in this direction |
HINT:
When removing the rear door opening trim cover sub-assembly, remove the double-sided tape.
Was this page helpful?
.png)