Exterior Panels / Trim

Reassembly

~3min read

REASSEMBLY

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL REAR DOOR OPENING TRIM MOULDING

HINT:

When installing the rear door opening trim moulding, heat the rear door opening trim cover sub-assembly using a heat light.

Heating Temperature

Item

Temperature

Quarter Pillar Garnish Sub-assembly

20 à 30 °C

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.
  • Prolonged contact with heated parts may cause burns.

*a

Hot Surface

*b

Heat Lamp

NOTICE:

Do not overheat the rear door opening trim cover sub-assembly.

(a) Clean the surface of the rear door opening trim cover sub-assembly.

(1) Using a heat light, heat the surface of the rear door opening trim cover sub-assembly.

(2) Remove the double-sided tape from the rear door opening trim cover sub-assembly.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat light, heat the rear door opening trim cover sub-assembly.

(c) Remove the protective sheet from a new rear door opening trim moulding.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the rear door opening trim moulding, as shown in the illustration.

HINT:

Install each rear door opening trim moulding along the rear door opening trim cover sub-assembly line.

*a

Line

2. INSTALL NO. 2 REAR PILLAR GARNISH PROTECTOR

HINT:

When installing the No. 2 rear pillar garnish protector, heat the rear door opening trim cover sub-assembly using a heat light.

Heating Temperature

Item

Temperature

Quarter Pillar Garnish Sub-assembly

20 à 30 °C

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.
  • Prolonged contact with heated parts may cause burns.

*a

Hot Surface

*b

Heat Lamp

NOTICE:

Do not overheat the rear door opening trim cover sub-assembly.

(a) Clean the surface of the rear door opening trim cover sub-assembly.

(1) Using a heat light, heat the surface of the rear door opening trim cover sub-assembly.

(2) Remove the double-sided tape from the rear door opening trim cover sub-assembly.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat light, heat the rear door opening trim cover sub-assembly.

(c) Remove the protective sheet from a new No. 2 rear pillar garnish protector.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the No. 2 rear pillar garnish protector, as shown in the illustration.

HINT:

Install the No. 2 rear pillar garnish protector along the rear door opening trim cover sub-assembly line.

*a

Line