Doors / Back Door
Removal
In this manual: Doors / Back Door
~2min read
REMOVAL
PRECAUTION / NOTICE / HINT
HINT:
- Repeat the same procedure for the right side and the left side.
- The following procedure applies to the left side.
PROCEDURE
1. REMOVE BACK DOOR STAY ASSEMBLY
CAUTION:
- Do not perform the work if the back door is not properly supported.

- The back door may fall and cause serious injury.
NOTICE:
- If possible, avoid touching the piston rod to prevent foreign matter from adhering to it. Be sure to hold the cylinder during maintenance.
- Do not handle the piston rod with cotton gloves or similar materials. Fibers may adhere to the rod and cause gas leakage.
- Do not apply any horizontal load to the back door stay to prevent deforming the piston rod.
(a) Using a screwdriver with its tip wrapped in protective tape, remove the 2 retaining rings as shown in the illustration. |
|
(b) Release the ball joint to remove the back door stay assembly.
NOTICE:
- Remove the back door stay assembly while supporting the back door with your hands.
- Remove the back door stay assembly while supporting the back door stay assembly with your hands.
2. REMOVE BACK DOOR STAY UPPER BRACKET
(a) Remove the 2 bolts and the back door stay upper bracket. |
![]() |
3. REMOVE BACK DOOR STAY LOWER BRACKET
(a) Remove the 2 bolts and the back door stay lower bracket. |
![]() |
Was this page helpful?


