Heater / Air Conditioning

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) after the parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Initialize Back Door Lock

Door Lock Control System

  • No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Air Mix)
  • Air conditioning radiator damper servo sub-assembly No. 2
  • Air Conditioning Amplifier Assembly

Initialize Servo Motor (Air Conditioning System)

DTCs are stored

PROCEDURE

1. REMOVE BLOWER ASSEMBLY

Click here

2. REMOVE HEATER COVER (without PTC heater)

Click here

3. REMOVE HEATER COVER NO. 2 (with PTC heater)

Click here

4. REMOVE QUICK HEATER ASSEMBLY (with PTC heater)

Click here

5. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

Click here

6. REMOVE AIR CONDITIONING WIRE HARNESS ASSEMBLY

Click here

7. REMOVE AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY NO. 1

Click here

8. REMOVE AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY NO. 2

Click here

9. REMOVE HEATER HOSE GROMMET

Click here

10. REMOVE HEATER CLAMP

Click here

11. REMOVE HEATER CORE SUB-ASSEMBLY

Click here

12. REMOVE COOLER EXPANSION VALVE

Click here

13. REMOVE HEAT EXCHANGER CASE

Click here

14. REMOVE RADIATOR CASE SUB-ASSEMBLY

Click here

15. REMOVE COOLER EVAPORATOR SUB-ASSEMBLY NO. 1

Click here

16. REMOVE COOLER THERMISTOR NO. 1

(a) Remove the No. 1 cooler thermistor.