Heater / Air Conditioning

Precautions

~3min read

PRECAUTION

PRECAUTIONS FOR HFO-1234yf (R1234yf) REFRIGERANT

(a) HFO-1234yf (R1234yf) Refrigerant

(1) Always use HFO-1234yf (R1234yf) refrigerant.

NOTICE:

  • Do not charge the system with refrigerant near open flames, as HFO-1234yf (R1234yf) is flammable.
  • When charging the system with refrigerant, make sure the area is well ventilated. Be especially careful in areas where gas can easily accumulate, such as below lifts in underground garages, because the gas is heavier than air.
  • Follow local regulations concerning flammable gases.
  • Be sure to use a refrigerant recovery unit compatible with HFO-1234yf (R1234yf) systems.

HINT:

The shape of the refrigerant charging service port has an exclusive design that complies with international standards specific to HFO-1234yf (R1234yf), to prevent refrigerant charging errors.

(b) Compressor Oil

(1) Always use VC100YF as the compressor oil.

(2) When air conditioning system parts are removed, quickly cover any areas exposed to the outside air with caps, vinyl tape, etc., because the oil used in HFO-1234yf (R1234yf) systems absorbs moisture easily.

(3) Be careful not to let the compressor oil vaporize, because the oil used in HFO-1234yf (R1234yf) systems has harmful effects on acrylic resins.

(c) Discharging

(1) When discharging the system, be sure to use a refrigerant recovery unit, refrigerant recycling system and refrigerant charger compatible with HFO-1234yf (R1234yf) systems.

(d) Refrigerant Gas Leak Check

(1) Using a gas leak detector, check for any refrigerant gas leaks.

HINT:

Be sure to use a gas leak detector compatible with HFO-1234yf (R1234yf) systems.

(2) Turn the ignition switch OFF when checking for refrigerant leaks.

HINT:

  • If the engine is running during the leak check, the leaking gas will be diluted in the air through the fan and blower, making detection more difficult.
  • If the air conditioning system is operating during the leak check, the refrigerant pressure in the system drops and it becomes more difficult for the gas to leak.
  • If the air conditioning system is operating during the leak check, an electronic gas leak detector will react to the sudden change in humidity caused by humid air from the drain hose, leading to an incorrect judgment.

PRECAUTIONS FOR PARTS REMOVAL AND INSTALLATION

(a) If refrigerant gets into your eyes

(1) Do not rub your eyes with your hands or a cloth.

(2) Consult an ophthalmologist.

(b) Handling Refrigerant (Container)

(1) Do not heat the container. If the container is heated or placed directly in boiling water, the pressure inside will become abnormally high and the container may burst.

(2) Do not drop or strike the container.

(3) Do not place the container near your face. Always wear protective goggles.

(c) Pipe Installation

(1) Always use new O-rings.

HINT:

When removing an O-ring, use a tool with a soft tip so as not to damage the pipe.

(2) Apply a sufficient amount of compressor oil to the O-ring.

(3) Route the hoses following their natural shape. Do not twist them or apply excessive force to bend them.

(4) Do not use cloth gloves, etc., because fibers caught on the O-rings may cause refrigerant gas leaks.