Adjustment
ADJUSTMENT
PRECAUTION / NOTICE / HINT
*a |
Centering Bolt |
*b |
Standard Bolt |
HINT:
- The centering bolts are used to temporarily fix the back door hinges to the door. The door cannot be adjusted while the centering bolts are installed. Replace the centering bolts with standard bolts (with washers) when making adjustments.
- The specified torque for standard bolts is shown in the standard bolt table.
Click here
.gif)
PROCEDURE
1. INSPECT BACK DOOR
(a) Make sure the clearances for zones "A" to "O" are within the standard ranges.
Standard clearanceArea | Measurement | Area | Measurement |
|---|---|---|---|
A |
7.1 to 11.1 mm (0.280 to 0.437 in.) |
B |
-1.0 to 3.0 mm (-0.039 to 0.118 in.) |
C |
7.1 to 11.1 mm (0.280 to 0.437 in.) |
D |
-1.0 to 3.0 mm (-0.039 to 0.118 in.) |
E |
-2.0 to 2.0 mm (-0.079 to 0.079 in.) |
F |
4.0 to 8.0 mm (0.157 to 0.315 in.) |
G |
3.5 to 8.5 mm (0.138 to 0.335 in.) |
H |
3.5 to 8.5 mm (0.138 to 0.335 in.) |
I |
3.3 to 7.3 mm (0.130 to 0.287 in.) |
J |
3.5 to 7.5 mm (0.138 to 0.295 in.) |
K |
2.4 to 5.4 mm (0.094 to 0.213 in.) |
L |
4.0 to 8.0 mm (0.157 to 0.315 in.) |
M |
2.8 to 5.8 mm (0.110 to 0.228 in.) |
N |
4.0 to 8.0 mm (0.157 to 0.315 in.) |
O |
3.8 to 6.8 mm (0.150 to 0.268 in.) |
- |
- |
2. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
Click here
![]()
3. ADJUST BACK DOOR
(a) Loosen the 4 hinge bolts on the back door and adjust the position of the back door. |
![]() |
(b) After adjustment, tighten the 4 hinge bolts on the back door.
Torque:
19 N·m {194 kgf·cm, 14 ft·lbf}
(c) Using a "TORX" T40 socket wrench, slightly loosen the 2 striker mounting screws. |
![]() |
(d) Using a brass bar and a hammer, tap the striker to adjust its position.
(e) After adjustment, use a "TORX" T40 socket wrench to tighten the 2 striker mounting screws.
Torque:
23 N·m {235 kgf·cm, 17 ft·lbf}
4. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER
Click here
![]()

