Reassembly
REASSEMBLY
PRECAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side as for the LH side.
- The procedure described below applies to the LH side.
PROCEDURE
1. INSTALL NO. 2 OUTER MOULDING RETAINER
(a) If using a new rear door outer moulding:
(1) Clean the rear surface of the new rear door outer moulding.
(b) When reusing the rear door outer moulding:
(1) Remove the double-sided tape from the rear surface of the rear door outer moulding.
(2) Remove any tape residue using a cleaning solvent.
(c) Install a new No. 2 outer moulding retainer.
(1) Remove the release paper from the surface of the No. 2 outer moulding retainer.
HINT:
After removing the release paper, do not let the adhesive surface come into contact with foreign matter.
(2) Install the No. 2 outer moulding retainer, as shown in the illustration. |
|
2. INSTALL REAR DOOR UPPER OUTER MOULDING PAD
(a) When using a new rear door outside moulding:
(1) Clean the surface of the new rear door outside moulding.
(b) When reusing the rear door lower outside moulding subassembly:
(1) Remove the double-sided tape from the rear door outside moulding.
(2) Remove any tape residue using a cleaning solvent.
(c) Install a new rear door outside moulding upper cushion.
(1) Remove the protective paper from the surface of the rear door outside moulding upper cushion.
HINT:
After removing the release paper, do not let the adhesive surface come into contact with foreign matter.
(2) Install the rear door outside moulding upper cushion as shown in the illustration. |
|

