Heater / Air Conditioning

Reassembly

~2min read

REASSEMBLY

PROCEDURE

1. INSTALL BLOWER RESISTOR (for Single Type)

(a) Engage the guides and install the blower resistor as shown in the illustration.

Install in this direction

2. INSTALL AIR FILTER ASSEMBLY (for Single Type)

(a) Engage the guides to install the air filter assembly.

(b) Reinstall the 2 screws.

3. INSTALL BLOWER DAMPER SERVO ASSY NO. 1 (for Single Type)

(a) Install the Blower Damper Servo Assy No. 1 as shown in the illustration.

Install in this direction

(b) Turn the Blower Damper Servo Assy No. 1 to engage the claw as shown in the illustration.

Install in this direction

(c) Connect the damper servo motor link.

4. INSTALL BLOWER RESISTOR (for Dual Type)

(a) Engage the guides and install the blower resistor as shown in the illustration.

Install in this direction

5. INSTALL AIR FILTER ASSEMBLY (for Dual Type)

(a) Install the air filter assembly using the 4 screws.

6. INSTALL BLOWER DAMPER SERVO ASSY NO. 1 (for Dual Type)

(a) Install the Blower Damper Servo Assy No. 1 as shown in the illustration.

Install in this direction

(b) Turn the Blower Damper Servo Assy No. 1 to engage the claw as shown in the illustration.

Install in this direction

7. INSTALL BLOWER MOTOR AND FAN ASSEMBLY (for Single Type)

(a) Install the blower motor and fan assembly using the 3 screws.

NOTICE:

Replace the blower motor and fan assembly if it has been dropped or subjected to a severe impact.

(b) Connect the connector.

8. INSTALL AIR PURIFICATION FILTER

(a) Install the air filter as shown in the illustration.

Install in this direction

NOTICE:

Make sure that the "UP" mark is facing the correct direction before installing the air purification filter.

9. INSTALL AIR FILTER COVER PLATE

(a) Engage the guide and claw and install the air filter plate as shown in the illustration.

Install in this direction (1)

Install in this direction (2)