Toyota Sienna Service Manual: Evaporative Emission System

DTC P043E Evaporative Emission System Reference Orifice Clog Up

DTC P043F Evaporative Emission System Reference Orifice High Flow

DTC P2401 Evaporative Emission System Leak Detection Pump Control Circuit Low

DTC P2402 Evaporative Emission System Leak Detection Pump Control Circuit High

DTC P2419 Evaporative Emission System Switching Valve Control Circuit Low

DTC SUMMARY

HINT: The 0.02 inch orifice is located inside the pump module.

DESCRIPTION

The circuit description can be found in the EVAP (Evaporative Emission) System.

INSPECTION PROCEDURE

Refer to the EVAP System.

MONITOR DESCRIPTION

5 hours*1 after the ignition switch is turned off, the electric vacuum pump creates negative pressure (vacuum) in the EVAP (Evaporative Emission) system. The ECM monitors for leaks and actuator malfunctions based on the EVAP pressure.

HINT: *1: If the engine coolant temperature is not below 35C (95F) 5 hours after the ignition switch is turned off, the monitor check starts 2 hours later. If it is still not below 35C (95F) 7 hours after the ignition switch is turned off, the monitor check starts 2.5 hours later.

*2: If there is only a small amount of fuel in the fuel tank, stabilizing the EVAP pressure takes longer than usual.

The leak detection pump creates negative pressure through the reference orifice. When the system is normal, the EVAP pressure is in 724 to 752 mmHg* and saturated within a minute.

If not, the ECM interprets this as a malfunction. The ECM will illuminate the MIL and set DTC if this malfunction is detected in consecutive drive cycle.

*: Typical valve