Audio / visual
No. 1 Speaker with box
In this manual: Audio / visual
~1min read
COMPONENTS



ON-VEHICLE INSPECTION
1. INSPECT NO.1 SPEAKER WITH BOX
HINT: Remove interior parts so that the No.1 speaker with box can be seen.
- Check the speaker installation.
OK: The speaker is securely installed.
If the result is not as specified, reinstall the No.1 speaker with box.
OK: The cone paper of the speaker is not torn.
If the result is not as specified, replace the No.1 speaker with box.REMOVAL
1. REMOVE REAR DOOR SCUFF PLATE
2. REMOVE REAR DOOR WEATHERSTRIP
3. REMOVE BACK DOOR WEATHERSTRIP
4. REMOVE BACK DOOR SCUFF PLATE
5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY
6. REMOVE NO. 1 SPEAKER ASSEMBLY WITH BOX

- Remove the 2 screws and No. 1 speaker assembly with box.
INSTALLATION
1. INSTALL NO. 1 SPEAKER ASSEMBLY WITH BOX

- Install the No. 1 speaker assembly with box with the 2 screws.
NOTICE: Tighten the screws in order shown in the illustration to install the No. 1 speaker assembly with box.
2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY
3. INSTALL BACK DOOR SCUFF PLATE
4. INSTALL BACK DOOR WEATHERSTRIP
5. INSTALL REAR DOOR WEATHERSTRIP
6. INSTALL REAR DOOR SCUFF PLATE
Test yourself
A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?