Toyota Sienna Quiz
Audio / visual

Stereo component speaker

In this manual: Audio / visual
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
6steps
~36min
2/5difficulty
Done 0 of 6

COMPONENTS

COMPONENTS

ON-VEHICLE INSPECTION

1. INSPECT STEREO COMPONENT SPEAKER

HINT: Remove interior parts so that the stereo component speaker can be seen.

  1. Check the speaker installation.

OK: The speaker is securely installed.

If the result is not as specified, reinstall the stereo component speaker speaker.

  • Visually check the speaker.

    • OK: The cone paper of the speaker is not torn.

    If the result is not as specified, replace the stereo component speaker speaker.
  • Speaker resistance check
    1. Disconnect the stereo component speaker speaker connector.
    2. Measure the resistance between the terminals of the speaker.

    Standard resistance: 1.2 to 2.2 Ω

    If the result is not as specified, replace the stereo component speaker speaker.

    REMOVAL

    1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH

    2. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY

    REMOVE STEREO COMPONENT SPEAKER ASSEMBLY
    1. Remove the 2 screws.
    2. Disconnect the connector and remove the stereo component speaker assembly.

    INSTALLATION

    1. INSTALL STEREO COMPONENT SPEAKER ASSEMBLY

    INSTALL STEREO COMPONENT SPEAKER ASSEMBLY
    1. Connect the connector.
    2. Install the stereo component speaker assembly with the 2 screws.

    NOTICE: Tighten the screws in order shown in the illustration to install the stereo component speaker assembly.

    2. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.