Toyota Sienna Quiz
Audio / visual

Rear speaker

In this manual: Audio / visual
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
4steps
~24min
2/5difficulty
Done 0 of 4

COMPONENTS

COMPONENTS
COMPONENTS

ON-VEHICLE INSPECTION

1. INSPECT REAR SPEAKER

HINT: Remove interior parts so that the rear speaker can be seen.

  1. Check the speaker installation.

OK: The speaker is securely installed.

If the result is not as specified, reinstall the rear speaker.

  • Visually check the speaker.

    • OK: The cone paper of the speaker is not torn.

    If the result is not as specified, replace the rear speaker.
  • Speaker resistance check
    1. Disconnect the rear speaker connector.
    2. Measure the resistance between the terminals of the speaker.

    Standard resistance:

    6 Speaker system: Approximately 4 Ω
    10 Speaker system:     Approximately 2.4 Ω

    If the result is not as specified, replace the rear speaker.

    REMOVAL

    1. REMOVE REAR DOOR SCUFF PLATE

    2. REMOVE REAR DOOR WEATHERSTRIP

    3. REMOVE BACK DOOR WEATHERSTRIP

    4. REMOVE BACK DOOR SCUFF PLATE

    5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY

    6. REMOVE REAR SPEAKER ASSEMBLY

    REMOVE REAR SPEAKER ASSEMBLY
    1. Disconnect the connector.
    2. Remove the 3 screws and the rear speaker assembly

    INSTALLATION

    1. INSTALL REAR SPEAKER ASSEMBLY

    INSTALL REAR SPEAKER ASSEMBLY
    1. Install the rear speaker assembly with the 3 screws.
    NOTICE: Tighten the screws in order shown in the illustration to install the rear speaker assembly.
  • Connect the connector.

    • 2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY

    3. INSTALL BACK DOOR SCUFF PLATE

    4. INSTALL BACK DOOR WEATHERSTRIP

    5. INSTALL REAR DOOR WEATHERSTRIP

    6. INSTALL REAR DOOR SCUFF PLATE

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.