Toyota Sienna Quiz
Audio / visual

No. 2 Speaker with box

In this manual: Audio / visual
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
4steps
~24min
2/5difficulty
Done 0 of 4

COMPONENTS

COMPONENTS
COMPONENTS
COMPONENTS

ON-VEHICLE INSPECTION

1. INSPECT NO.2 SPEAKER WITH BOX

HINT: Remove interior parts so that the No.2 speaker with box can be seen.

  1. Check the speaker installation.

OK: The speaker is securely installed.

If the result is not as specified, reinstall the No.2 speaker with box.

  • Visually check the speaker.

    • OK: The cone paper of the speaker is not torn.

    If the result is not as specified, replace the No.2 speaker with box.
  • Speaker resistance check
    • INSPECT NO.2 SPEAKER WITH BOX
    1. Disconnect the front No.2 speaker with box connector.
    2. Measure the resistance between the terminals of the speaker.

    NOTICE: The speaker should not be removed for checking.

    Standard resistance

    Standard resistance

    If the result is not as specified, replace the No.2 speaker with box.

    REMOVAL

    1. REMOVE REAR DOOR SCUFF PLATE LH

    2. REMOVE REAR DOOR WEATHERSTRIP LH

    3. REMOVE BACK DOOR WEATHERSTRIP

    4. REMOVE BACK DOOR SCUFF PLATE

    5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH

    6. REMOVE NO. 2 SPEAKER ASSEMBLY WITH BOX

    REMOVE NO. 2 SPEAKER ASSEMBLY WITH BOX
    1. Disconnect the connector.
    2. Remove the 5 bolts and No. 2 speaker assembly with box.

    INSTALLATION

    1. INSTALL NO. 2 SPEAKER ASSEMBLY WITH BOX

    INSTALL NO. 2 SPEAKER ASSEMBLY WITH BOX
    1. Install the No. 2 speaker assembly with box with the 5 bolts.
    NOTICE: Tighten the bolts in order shown in the illustration to install the No. 2 speaker assembly with box.
  • Connect the connector.

    • 2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY LH

    3. INSTALL BACK DOOR SCUFF PLATE

    4. INSTALL BACK DOOR WEATHERSTRIP

    5. INSTALL REAR DOOR WEATHERSTRIP LH

    6. INSTALL REAR DOOR SCUFF PLATE LH

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.