Toyota Tacoma Quiz
Park Assist / Monitoring

Steering Angle Sensor (C1A47)

In this manual: Park Assist / Monitoring
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the spiral cable with sensor sub-assembly via CAN communication.

DTC Code

DTC Detection Condition

Trouble Area

C1A47

A fail flag is transmitted from the steering sensor
  • Spiral cable with sensor sub-assembly
  • Blind spot monitor sensor LH
  • Blind spot monitor sensor RH
CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

PROCEDURE

  1. CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again. ).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK
NG

  1. REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Replace the spiral cable with sensor sub-assembly with a new or normally functioning one (See page ).

NEXT

  1. CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again. ).

(b) Recheck for DTCs and check if the same DTC is output again.

Result

Result

Proceed to

No DTC is output

A

DTC is output from the blind spot monitor sensor LH (master)

B

DTC is output from the blind spot monitor sensor RH (slave)

C
A

END (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY WAS DEFECTIVE)
B

REPLACE BLIND SPOT MONITOR SENSOR LH
C

REPLACE BLIND SPOT MONITOR SENSOR RH

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.