Toyota Tacoma Quiz
Park Assist / Monitoring

Vehicle Speed Sensor (C1A45)

In this manual: Park Assist / Monitoring
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC Code

DTC Detection Condition

Trouble Area

C1A45

A fail flag is transmitted from the skid control ECU (brake actuator assembly).
  • Vehicle stability control system
  • Blind spot monitor sensor LH
  • Blind spot monitor sensor RH
CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

PROCEDURE

  1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for vehicle stability control system DTCs.

  • for Hydraulic Brake Booster (See page for Vacuum Brake Booster (See page for Vacuum Brake Booster (See page )
  • for Vacuum Brake Booster (See page ) )

OK:

Vehicle stability control system DTCs are not output.

Result

Result

Proceed to

OK

A

NG (for Hydraulic Brake Booster)

B

NG (for Vacuum Brake Booster)

C
B

GO TO VEHICLE STABILITY CONTROL SYSTEM
C

GO TO VEHICLE STABILITY CONTROL SYSTEM
A

  1. CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again (See page ).

(b) Recheck for DTCs and check if the same DTC is output again (See page Result ).

Result

Result

Proceed to

No DTC is output

A

DTC is output from the blind spot monitor sensor LH (master)

B

DTC is output from the blind spot monitor sensor RH (slave)

C
A

USE SIMULATION METHOD TO CHECK
B

REPLACE BLIND SPOT MONITOR SENSOR LH
C

REPLACE BLIND SPOT MONITOR SENSOR RH

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.