Brake
Brake Warning Light does not Come ON
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration zero point calibration.
Click here 
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
(a) Check if CAN communication system DTCs are output.
Click here 
Result | Proceed to |
DTCs are not output |
A |
DTCs are output |
B |
| B |
 |
INSPECT CAN COMMUNICATION SYSTEM |
| A |
 |
|
PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT)
(a) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test. ABS/VSC/TRAC
Tester Display | Measurement Item | Control Range | Diagnostic Note |
Brake Warning Light |
Brake warning light |
Warning light OFF/ON |
Observe combination meter assembly |
ABS/VSC/TRAC
Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
Brake Warning Light |
Brake warning light |
ON or OFF |
ON: Warning light on
OFF: Warning light off |
- |
(b) Check the operating condition of the brake warning light when operating it using the Techstream.
Result | Proceed to |
Brake warning light in the Data List does not change using the Active Test |
A |
Brake warning light in the Data List turns ON/OFF using the Active Test |
B |
| A |
 |
REPLACE BRAKE ACTUATOR ASSEMBLY |
| B |
 |
|
INSPECT COMBINATION METER ASSEMBLY
(a) Enter the following menus: Body Electrical / Combination Meter / Active Test.
Click here 
(b) Perform the Active Test of the combination meter assembly using the Techstream.
(c) Check the combination meter assembly.
OK:
The brake warning light turns on or off in accordance with the Techstream operation.
| OK |
 |
REPLACE BRAKE ACTUATOR ASSEMBLY |
| NG |
 |
INSPECT METER / GAUGE SYSTEM |
|
Was this page helpful?