Control Module Communication Bus OFF (U0073,U0100,U0114,U0123,U0126)
In this manual: Brake
~2min read
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the ECM, steering angle sensor (spiral with sensor cable sub-assembly), yaw rate and acceleration sensor (airbag sensor assembly) and 4WD control ECU via CAN communication.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
U0073
Control Module Communication Bus OFF
The +BS terminal voltage is between 9.6 and a 16.5 V and a bus OFF state occurs for 0.8 seconds or more.
CAN communication system
U0100
Lost Communication with ECM / PCM
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h or more, and signals cannot be sent to the ECM for 1 second or more.
CAN communication system
Skid control ECU (brake actuator assembly)
ECM
U0114
Lost Communication with 4WD Control ECU
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h or more, and signals from the 4WD control ECU cannot be received for 1 second or more.
CAN communication system
Skid control ECU (brake actuator assembly)
4WD control ECU
U0123
Lost Communication with Yaw Rate Sensor Module
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h or more, and signals from the yaw rate and acceleration sensor cannot be received for 1 second or more.
CAN communication system
Skid control ECU (brake actuator assembly)
Yaw rate and acceleration sensor (airbag sensor assembly)
U0126
Lost Communication with Steering Angle Sensor Module
The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h or more, and signals from the steering angle sensor cannot be received for 1 second or more.
CAN communication system
Skid control ECU (brake actuator assembly)
Steering angle sensor (spiral with sensor cable sub-assembly)
PROCEDURE
CHECK DTC OUTPUT (HEALTH CHECK)
(a) Clear the DTCs.
Click here
(b) Turn the ignition switch off.
(c) Turn the ignition switch to ON.
(d) Enter the following menus: System Select / Health Check.
(e) Check for DTCs.
Result
Proceed to
DTCs for related systems are output together with DTC U0073, U0100, U0114, U0123 or U0126.
A
U0073, U0100, U0114, U0123 or U0126 is output
B
DTCs are not output
C
A
GO TO DIAGNOSTIC TROUBLE CODE CHART (RELATED SYSTEM)