This DTC is stored when the skid control ECU (brake actuator assembly) judges that an abnormality occurred in the circuit used to operate the pump motor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1428
Motor Circuit Malfunction
Any of the following is detected:
When the pump motor is not operating and the pump motor voltage is continuously 0.93 V or higher for 10 seconds.
When a malfunction occurs in the pump motor circuit.
When the switching voltage of the pump motor decreases while the pump motor is operating.
When a malfunction occurs in the input voltage of the pump motor after the pump motor is operated.
Pump motor circuit
WIRING DIAGRAM
Refer to DTC C146C.
Click here
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.
Click here
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (+BM TERMINAL)
(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK:
The connector is securely connected.
*a
Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))
(b) Disconnect the A57 skid control ECU (brake actuator assembly) connector.
(c) Check both the connector case and the terminals for deformation and corrosion.
OK:
No deformation or corrosion.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
A57-1 (+BM) - Body ground
Always
11 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (+BM CIRCUIT)
OK
CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
A57-13 (GND2) - Body ground
Always
Below 1 Ω
*a
Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)
OK
RECONFIRM DTC
(a) Reconnect the A57 skid control ECU (brake actuator assembly) connector.