DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch assembly signals and uses them to determine whether or not the brakes are applied.
The skid control ECU (brake actuator assembly) has a detection circuit that it uses to detect an open in the stop light input line.
If the skid control ECU (brake actuator assembly) detects an open in this circuit, it will store this DTC.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
C1425 |
Open in Stop Light Switch Circuit |
With the stop light control relay not operating, an open circuit continuously occurs in the input line of the stop light switch assembly for 2.5 seconds or more. |
- Wire harness or connector
- Stop light switch assembly
- Skid control ECU (brake actuator assembly)
|
WIRING DIAGRAM
NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.
Click here 
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK STOP LIGHT SWITCH OPERATION
(a) Check that all stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
OK:
Condition | Illumination Condition |
Brake pedal depressed |
On |
Brake pedal released |
Off |
| NG |
 |
INSPECT STOP LIGHT CIRCUIT |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (STP TERMINAL)
(a) Turn the ignition switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connector.
OK:
The connector is securely connected.
(c) Disconnect the A57 skid control ECU (brake actuator assembly) connector.
(d) Check both the connector case and the terminals for deformation and corrosion.
OK:
No deformation or corrosion.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
A57-2 (STP) - Body ground |
Stop light switch assembly on (Brake pedal depressed) |
8 to 14 V |
A57-2 (STP) - Body ground |
Stop light switch assembly off (Brake pedal released) |
Below 1.5 V |
|
 |
*a |
Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly)) |
|
|
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR (STP CIRCUIT) |
| OK |
 |
|
RECONFIRM DTC
(a) Clear the DTCs.
Click here 
(b) Turn the ignition switch off.
(c) Start the engine.
(d) Depress the brake pedal several times to test the stop light circuit.
(e) Check if the same DTC is output.
Click here 
Result | Proceed to |
C1425 is not output |
A |
C1425 is output |
B |
| A |
 |
USE SIMULATION METHOD TO CHECK |
| B |
 |
REPLACE BRAKE ACTUATOR ASSEMBLY |
|