The combination meter assembly receives engine speed signals from the ECM via the CAN line. The combination meter assembly displays engine speed data that is calculated based on the data received from the ECM.
WIRING DIAGRAM
PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output (See page ).
Result
Result
Proceed to
CAN communication system DTC is not output
A
CAN communication system DTC is output
B
B
GO TO CAN COMMUNICATION SYSTEM
A
PERFORM ACTIVE TEST USING TECHSTREAM (TACHOMETER)
(a) Operate the Techstream according to the display and select "Active Test" (See page ).
Combination Meter:
Tester Display
Test Part
Control Range
Diagnostic Note
Tachometer Operation
Tachometer
0, 1000, 2000, 3000, 4000, 5000, 6000, 7000
Perform the test with the vehicle stopped and engine idling
OK:
Needle indication is normal.
HINT:
Confirm that the vehicle is stopped and engine idling.
NG
REPLACE COMBINATION METER ASSEMBLY
OK
READ VALUE USING TECHSTREAM (TACHOMETER)
(a) Operate the Techstream according to the display and select "Data List" (See page ).
Combination Meter:
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Engine Rpm
Engine speed/Min.: 0, Max.: 12750
Idling: 650 to 750
Unit: rpm
OK:
Engine speed displayed on Techstream is almost the same as actual engine speed.
OK
REPLACE COMBINATION METER ASSEMBLY
NG
READ VALUE USING TECHSTREAM (ENGINE SPEED)
(a) Operate the Techstream according to the display and select "Data List" (See page ).
Engine:
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Engine Speed
Engine speed/Min.: 0, Max.: 16838
Idling: 650 to 750
Unit: rpm
OK:
Engine speed displayed on Techstream is almost the same as actual engine speed.