Back Door Courtesy Switch

1. REMOVE BACK DOOR PANEL TRIM ASSEMBLY

2. REMOVE BACK DOOR LOCK ASSEMBLY

(a) Disconnect the connector.

(b) Disengage the clamp.

(c) Remove the bolt.

(d) Remove the 3 bolts and back door lock assembly.

1. INSPECT BACK DOOR COURTESY SWITCH (BACK DOOR LOCK ASSEMBLY)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

If the result is not specified, replace the back door lock assembly.

1. INSTALL BACK DOOR LOCK ASSEMBLY

(a) Apply MP grease to the sliding parts of the back door lock assembly.

(b) Apply adhesive to the threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(c) Install the back door lock assembly with the 3 bolts. Torque: 8 N·m {82 kgf·cm, 71 in·lbf}

(d) Install the bolt. Torque: 8 N·m {82 kgf·cm, 71 in·lbf}

(e) Engage the clamp.

(f) Connect the connector.

2. INSTALL BACK DOOR PANEL TRIM ASSEMBLY