Toyota Venza Quiz
Lighting (int)

Door Courtesy Light

In this manual: Lighting (int)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE COURTESY LIGHT ASSEMBLY

(a) Using a screwdriver wrapped with protective tape, disengage the claw.

Text in Illustration

*1

Protective Tape

(b) Disconnect the connector and remove the courtesy light assembly.

Inspection INSPECTION PROCEDURE

1. INSPECT COURTESY LIGHT ASSEMBLY

(a) Connect a positive (+) lead from the battery to terminal 2 and a negative (-) lead to terminal 1.

(b) Check that the courtesy light comes on.

OK:

Courtesy light comes on.

Text in Illustration

*1

Component without harness connected

(Courtesy Light Assembly)

If the result is not as specified, replace the bulb or courtesy light assembly.

Installation INSTALLATION PROCEDURE

1. INSTALL COURTESY LIGHT ASSEMBLY

(a) Connect the connector.

(b) Engage the claw to install the courtesy light assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.