Toyota Venza Quiz
Lighting (int)

Luggage Compartment Room Light

In this manual: Lighting (int)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE NO. 2 ROOM LIGHT ASSEMBLY

(a) Using a moulding remover, disengage the claw.

(b) Disconnect the connector and remove the No. 2 room light assembly.

Inspection INSPECTION PROCEDURE

1. INSPECT NO. 2 ROOM LIGHT ASSEMBLY

(a) Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2.

(b) Check that the light comes on.

OK:

Light comes on.

Text in Illustration

*1

Component without harness connected

(No. 2 Room Light Assembly)

If the result is not as specified, replace the bulb or No. 2 room light assembly.

Installation INSTALLATION PROCEDURE

1. INSTALL NO. 2 ROOM LIGHT ASSEMBLY

(a) Connect the connector.

(b) Engage the claw to install the No. 2 room light assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.