Toyota Venza Quiz
Lighting (int)

Room Light

In this manual: Lighting (int)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE SPOT LIGHT ASSEMBLY

(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 8 claws to remove the 2 spot light lenses.

Text in Illustration

*a

Protective Tape

*b

Front

(b) Using a screwdriver with its tip wrapped with protective tape and moulding remover, disengage the 2 claws (A).

Text in Illustration

*a

Protective Tape

*b

Front

(c) Disengage the 4 claws (B) and disconnect the spot light housing.

(d) Using a screwdriver, disengage the 8 claws and clamp to remove the spot light housing from the 2 map light sub-assemblies.

Text in Illustration

*1

Map Light Sub-assembly

2. REMOVE SPOT LIGHT BULB

(a) Remove the 2 spot light bulbs from the 2 map light sub-assemblies.

Installation INSTALLATION PROCEDURE

1. INSTALL SPOT LIGHT BULB

(a) Install the 2 spot light bulbs to the 2 map light sub-assemblies.

2. INSTALL SPOT LIGHT ASSEMBLY

(a) Engage the 8 claws and clamp to connect the spot light housing to the 2 map light sub-assemblies as shown in the illustration.

Text in Illustration

*1

Map Light Sub-assembly

*a

Front

(b) Engage the 6 claws to install the spot light housing.

Text in Illustration

*a

Front

(c) Engage the 8 claws to install the 2 spot light lenses.

Text in Illustration

*a

Front

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.