Ignition Key Cylinder Light

Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE

1. INSPECT TRANSPONDER KEY AMPLIFIER

(a) Connect a positive (+) lead from battery to terminal 2 and a negative (-) lead to terminal 6.

(b) Check that the light comes on.

OK:

The light comes on.

Text in Illustration

*1	Component without harness connected (transponder key amplifier)

If the result is not as specified, replace the transponder key amplifier.

Removal REMOVAL PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE

2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY

3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

4. REMOVE LOWER STEERING COLUMN COVER

5. REMOVE UPPER STEERING COLUMN COVER

6. REMOVE TRANSPONDER KEY AMPLIFIER

(a) Disengage the 2 claws and disconnect the transponder key amplifier as shown in the illustration.

(b) Disconnect the connector and remove the transponder key amplifier.

Installation INSTALLATION PROCEDURE

1. INSTALL TRANSPONDER KEY AMPLIFIER

(a) Connect the connector to the transponder key amplifier.

(b) Engage the 2 claws and install the transponder key amplifier.

2. INSTALL UPPER STEERING COLUMN COVER

3. INSTALL LOWER STEERING COLUMN COVER

4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY

6. INSTALL FRONT DOOR SCUFF PLATE