Communication Malfunction No. 1 (B2797)

This DTC is stored when an error occurs in communication between the transponder key amplifier and the transponder key ECU assembly.

HINT:

Some noise is found in the communication line.

NOTICE:

If the transponder key ECU assembly is replaced, register the key and ECU communication ID (See page ).

1. CHECK KEY

(a) Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip. Result: Result Proceed to Key is near other keys and/or key ring is in contact with key grip. A Key is not near other keys and key ring is not in contact with key grip. B

B

GO TO STEP 3

A

1. CHECK DTC OUTPUT

(a) Separate the keys from each other or remove the key ring.

(b) Clear the DTCs (See page ).

(c) Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.

OK:

No DTC is output.

OK

END (KEYS WERE POSITIONED TOO CLOSE TO EACH OTHER)

NG

1. REPLACE TRANSPONDER KEY AMPLIFIER

(a) Replace the transponder key amplifier (See page ).

NEXT

1. CHECK ENGINE START

(a) Check that the engine starts.

OK:

The engine starts.

OK

END (TRANSPONDER KEY AMPLIFIER WAS DEFECTIVE)

NG

REPLACE TRANSPONDER KEY ECU ASSEMBLY