Inspection
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
7 (SS1) - 5 (GND) |
Not pushed |
10 kΩ or higher |
2 (SS2) - 5 (GND) |
Not pushed |
10 kΩ or higher |
7 (SS1) - 5 (GND) |
Pushed |
15 Ω |
2 (SS2) - 5 (GND) |
Pushed |
15 Ω |
If the result is not as specified, replace the engine switch.
(b) Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.
HINT:
- If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.
- If the voltage is too low, the indicator light will not illuminate.
OK:
Measurement Condition | Specified Condition |
|---|---|
Battery positive (+) → Terminal 11 (SWIL) Battery negative (-) → Terminal 4 (COM) or 5 (GND) |
Illuminates |
Battery positive (+) → Terminal 12 (INDS) Battery negative (-) → Terminal 4 (COM) or 5 (GND) |
Illuminates |
Battery positive (+) → Terminal 13 (INDW) Battery negative (-) → Terminal 4 (COM) or 5 (GND) |
Illuminates |
Text in Illustration *1 |
Indicator Light |
If the result is not as specified, replace the engine switch.
Test yourself
A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.