Toyota Venza Quiz
Theft Deterrent / Keyless Entry

Lost Communication with ECM / PCM "A" (U0100)

In this manual: Theft Deterrent / Keyless Entry
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
DESCRIPTION

The power management control ECU receives shift position information from 2 sources. It receives a shift position P signal from the shift lock control unit assembly via a direct line, and shift position information from the ECM via CAN. If the information from these 2 sources is inconsistent, this DTC will be stored.

DTC No.

DTC Detection Condition

Trouble Area

U0100

Shift position information from ECM (via CAN) and shift lock control unit assembly (direct line) is inconsistent
  • CAN communication system
  • Power management control ECU
  • ECM
  • Wire harness or connector
WIRING DIAGRAM

Refer to CAN communication system (See page ).


CAUTION / NOTICE / HINT

NOTICE:

When the power management control ECU is replaced with a new one and the cable from the negative (-) battery terminal is connected, the power source mode becomes the on (IG) mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.

PROCEDURE

  1. REFER TO CAN COMMUNICATION SYSTEM

See page



NEXT

END

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.