Toyota Venza Quiz
Heating / Air Conditioning

Reassembly

In this manual: Heating / Air Conditioning
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REASSEMBLY PROCEDURE

1. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY

(a) Install the front blower motor sub-assembly with the 3 screws.

2. INSTALL AIR INLET SERVO MOTOR SUB-ASSEMBLY

(a) Install the air inlet servo motor sub-assembly with the 3 screws.

(b) Engage the 6 claws.

(c) install the blower case with the screw.

3. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY

(a) Install the air conditioning amplifier assembly with the 2 screws.

4. INSTALL CLEAN AIR FILTER

(a) Install the clean air filter as shown in the illustration.

5. INSTALL AIR FILTER COVER PLATE

(a) Engage the 2 claws to install the air filter cover plate.

6. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY

(a) Engage the 4 claws to install the No. 1 air duct sub-assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.