Body assembly work, exterior
Roof trim / roof rail
In this manual: Body assembly work, exterior
3steps
~18min
2/5difficulty
Done 0 of 3
Assembly overview - Roof rail

- Roof rail
- Threaded stud
- with seals
- Component of roof rail
- Hex nut
- 4 pieces, per side
- Tightening torque: 9 N·m
Remove and install roof rail

Removing
![]()
Note
The headliner is only removed if the roof rail is removed on both sides.
- Detach headliner on the corresponding side → Body - Interior assembly work.
- Unscrew hex nuts -3- at front and rear.
- Lift roof rail -1- straight up and off.
Installing
- Check seal on threaded studs -2- for damage and ensure it seats correctly.
- Place roof rail -1- straight on from above.
- Tighten hex nuts -3- at front and rear.
Tightening torques
- Nuts
Was this page helpful?