Gearbox oil
Check gearbox oil level
The gearbox oil level can only be checked if the gearbox oil is completely drained and then refilled
Drain and refill gearbox oil
Required special tools, testers and equipment, and auxiliary items
- Torque wrench -VAS 6583-
- Commercially available hose (approx. 600 mm long), outside diameter max. 22 mm
- Commercially available funnel

Preparation
Gearbox oil → Electronic Parts Catalogue (ETKA).
- The filler plug -arrow- is removed later in the procedure to fill the gearbox.
- Clean gearbox in area of filler plug -arrow-.

Drain gearbox oil -arrow-
To catch the gearbox oil, use a clean graduated container with approx. 2.0 L capacity
- Tighten oil drain plug -arrow- to specified torque.

Fill gearbox oil
- The oil drain plug is tightened to specified torque.
Gearbox oil → Electronic Parts Catalogue (ETKA)
Top up gearbox oil quantity in the container
The gearbox is filled through the bore for the filler plug -arrow-.
It is accessible from below the vehicle.
- Remove filler plug -arrow-.
![]()
Note
The area below the filler plug -arrow- must be covered with a rag.

- To fill, use a commercially available hose (approx. 600 mm long), outside diameter max. 22 mm, and a commercially available funnel:
- Route hose -A- through the engine compartment.

- Insert hose -A- into the receiving bore of the filler plug and fill gearbox.

- Install filler plug and tighten retaining bolt -arrow- to specified torque.
- If oil has come into contact with the gearbox or other components, it must be carefully removed.
Tightening torques


