5-speed manual transmission 0CF

Gearbox housing, clutch housing

22steps
~132min
4/5difficulty
010203040503022N·mlb·ft
Tightening torque found on this page
Done 0 of 22

Assembly overview - gearbox housing and clutch housing

VW UP. 5 Gang-Schaltgetriebe 0CF

  1. Gearbox housing
    • If replacing: adjust input shaft, output shaft and differential
  2. Bushing
    • for shift shaft
    • replace after removal
  3. Fitting sleeve
    • 2 pieces
  4. Outer race/tapered roller bearing
    • for input shaft
    • Pull out of gearbox housing and press into gearbox housing
    • If replacing: adjust input shaft
  5. Outer race/tapered roller bearing
    • for output shaft
    • Pull out of gearbox housing and press into gearbox housing
    • If replacing: adjust output shaft
  6. Outer race/tapered roller bearing
    • for output shaft
    • Pull out of clutch housing and press into clutch housing
    • If replacing: adjust output shaft
  7. Adjusting shim
    • for output shaft
    • Adjustment overview
  8. Outer race/tapered roller bearing
    • for input shaft
    • Pull out of clutch housing and press into clutch housing
    • If replacing: adjust input shaft
  9. Adjusting shim
    • for input shaft
    • Adjustment overview
  10. Seal ring for driveshaft
    • replace after removal
  11. ball stud
    • Remove and install
  12. Seal ring for drive shaft, right
    • replace after removal
    • Replace with gearbox installed
  13. Oil drain plug
    • 30 N·m
  14. Clutch housing
    • If replacing: adjust input shaft, output shaft and differential
  15. Stop washer
  16. Adjusting shim
    • for differential
    • Adjustment overview
  17. Outer race/tapered roller bearing
    • for differential
    • Pull out of clutch housing and press into clutch housing
    • If replacing: adjust differential
  18. Reverse shaft
    • replace after removal
    • is damaged during removal
  19. Outer race/tapered roller bearing
    • for differential
    • Pull out of gearbox housing and press into gearbox housing
    • If replacing: adjust differential
  20. Stop washer
  21. Magnet
    • is held by the housing parting surface
  22. Seal ring for drive shaft, left
    • replace after removal
    • Replace with gearbox installed

Mounting to engine and gearbox bracket

VW UP. 5 Gang-Schaltgetriebe 0CF

Required special tools, testers and equipment, and auxiliary items

  • Clamping block -VW 313-
  • Gearbox holder -T10484-
  • Torque wrench -V.A.G 1331-
  • Drip tray -VAS 6208-

- Secure gearbox to gearbox support -T10484- -arrows-.

-A- = Bolts M10 x 35.

VW UP. 5 Gang-Schaltgetriebe 0CF