Park/Neutral Position Switch (automatic transmission)

GENERAL INFORMATION

Park/Neutral Position Switch

Park/Neutral Position Switch and back-up lamp switch

1. BOLT, TORQUE 30 N.m

2. SWITCH.

3. RANGE SELECTOR SHAFT.

4. ADJUSTMENT HOLE IN SWITCH HOUSING.

5. MEASURING PIN, 2.34 mm DIAMETER

Switch electrical connector with T-type retainer

1. PARK/NEUTRAL POSITION SWITCH AND BACK-UP LAMP SWITCH.

2. SWITCH CONNECTOR T-SHAPED RETAINER TAB

The Park/Neutral Position switch monitors the position of the selector lever.

automatic transmission. The switch signal is used by the ECU when

controlling the engine idle air control valve..

Warning.

Do not operate the vehicle with the switch connector disconnected.

Park/Neutral, as this will cause engine idle to malfunction.

Trouble code 24 (vehicle speed sensor fault) may also be output.

vehicle)..

Remove or disconnect:

PROCEDURE.

1. Range selector mechanical linkage..

2. Electrical connector..

3. Mounting bolts..

4. Switch..

SWITCH REPLACEMENT – INSTALLATION OF USED SWITCH.

Installation

PROCEDURE.

1. Turn range selector shaft to neutral position..

2. Switch, aligning its hole with the flats on the shaft..

3. Install bolts, do not tighten..

4. Insert measuring pin into the switch housing adjustment hole

pin and turn the switch so that the pin is depressed 9 mm..

5. Tighten bolts..

Remove or disconnect:

PROCEDURE.

Remove the pin..

Warning.

After adjusting the switch, check the starter lockout.

engine in all range selector positions except Neutral and Park. If the engine starts in other selector positions, repeat the adjustment..

SWITCH REPLACEMENT – INSTALLATION OF NEW SWITCH.

Installation

PROCEDURE.

1. Turn range selector shaft to neutral position..

2. Switch, aligning its hole with the flats on the shaft..

3. Install and tighten bolts. If the bolt holes do not align with the threaded

holes in the transmission case, check the position of the shaft and

set it to neutral position without turning the switch. The switch is in neutral position. If the switch was turned, it is necessary to

adjust it in the same way as a used switch..

Warning.

After adjusting the switch, check the starter lockout.

engine in all range selector positions except Neutral and Park. If the engine starts in other selector positions, perform

the adjustment used when installing a used switch..

Adjust..

PROCEDURE.

1. Move the range selector to neutral position..

2. Loosen switch mounting bolts..

3. Turn the switch on the shaft until the adjusting hole aligns.

of the switch with the hole in the holder bracket. Insert the measuring pin.

diameter 2.34 mm to a depth of 15 mm.

4. Tighten the bolts to the specified torque.

5. Remove the measuring pin.