Hyundai Elantra CN7 Quiz

Ignition Switch, Ignition Coils

In this manual: Ignition Switch, Ignition Coils
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read

IGNITION SWITCH INSPECTION

1. Disconnect the ignition switch connector located under the steering column.

2. Check the continuity between the connector terminals as shown in the illustration.

ПРИМЕЧАНИЕ

цепи между выводами.indicates that there is continuity between the terminals.

ПРОВЕРКА КАТУШЕК ЗАЖИГАНИЯ

IGNITION COIL INSPECTION

1. Измерьте сопротивление первичной обмотки катушки между выводами 1 и 2 разъемов

1. Measure the primary winding resistance between terminals 1 and 2 of connectors C18-2 and C68-1 (ignition coil for cylinders No. 1 and No. 4) of the ignition coil, and between terminals 1 and 2 of connectors C18-1 and C68-2 (ignition coil for cylinders No. 2 and No. 3) of the ignition coil.

Standard value: 0.5 ± 0.05 Ω

2. Измерьте сопротивление вторичной обмотки между выводами высокого напряжения

2. Measure the secondary winding resistance between the high-voltage terminals for cylinders No. 1 and No. 4, and between the high-voltage terminals for cylinders No. 2 and No. 3.

Standard value: 12.1 ± 1.8 kΩ

Before measuring the secondary winding resistance, make sure the ignition coil connector is disconnected.

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.