Power Windows

The ignition switch must be in the ON position to raise or lower the windows. Each door has a window switch to control that door window. The driver has a power window lock switch that can disable operation of the passenger windows. Power windows will operate for approximately 30 seconds after the ignition switch is turned to ACC or LOCK/OFF. However, if either front door is opened, the power windows will not operate even during this 30-second period.

WARNING

To avoid serious injury or death, do not extend your head, arms, or body outside the window while driving.

Information

• In cold and humid climates, power window operation may be affected by freezing conditions.
• While driving with the rear windows down or the sunroof (if equipped) open (or partially open), your vehicle may exhibit wind buffeting or pulsating noise. This noise is normal and may be reduced or eliminated by taking the following actions. If the noise occurs with one or both rear windows down, partially lower both front windows approximately one inch. If you feel the noise with the sunroof open, slightly close the sunroof.

Opening and Closing the Window

To open:

Press the window switch down to the first detent (5). Release the switch when you want the window to stop.

Closing:

Pull the window switch up to the first detent (5). Release the switch when you want the window to stop.

Automatic Window Down

Press the power window switch down briefly to the second detent (6) to fully lower the window, even after the switch is released. To stop the window at a desired position while it is moving, pull up or press down and release the switch.

Automatic Window Up/Down

Press or pull the window switch briefly to the second detent (6) to fully lower or raise the window, even after the switch is released. To stop the window at a desired position while it is moving, pull up or press down and release the switch.

Resetting the Power Windows

If the power windows do not operate normally, the automatic window system must be reset as follows:

1. Turn the ignition switch to the ON position.

2. Close the window and continue pulling the window switch for at least one second.

If the power windows still do not operate properly after resetting, have the system checked by an authorized HYUNDAI dealer.

WARNING

The automatic reverse function is not activated while the window system is being reset. Make sure body parts or other objects are clear before closing the windows to avoid injury or vehicle damage.