Height adjuster (if equipped)

The height of the shoulder belt anchor can be adjusted to one of 3 positions for maximum comfort and safety.

The upper part must be adjusted so that it passes across the chest and the middle of the shoulder toward the door, not toward the neck.

To adjust the height of the belt anchor, lower or raise the adjuster to the appropriate position.

To raise the height adjuster, pull it upward (1). To lower it, push it downward (3) while pressing the button (2).

Release the button to lock it in position. Slide the height adjuster to make sure it is locked in position.

WARNING Make sure the shoulder anchor is locked in the correct height position. Never place the upper belt across the neck or face. Improperly positioned belts can cause serious injury in an accident.

WARNING Improperly positioned belts can cause serious injury in an accident. Observe the following precautions when adjusting the belts: - Position the lap portion as low and as comfortably as possible on the hips, not on the waist. This allows the strong pelvic bones to absorb the force of the impact, reducing the risk of internal injuries. - Place one arm under the belt on the shoulder and the other above the belt itself, as shown in the figure.

When using the rear center seat belt, use the buckle marked "CENTER" (if equipped).

To unfasten the seat belt:

The belt is released by pressing the button (1) on the buckle.

When released, the belt should retract automatically into the retractor.

If this does not happen, check the belt to make sure it is not twisted, then try again.