Master Cylinder Repair Procedures

DEPOSIT

1. 1
   Turn the ignition key to the OFF position and disconnect the negative (-) battery cable.
2. 2
   Disconnect the brake fluid level switch connector from the reservoir.

   

3. 3
   Drain the brake fluid from the master cylinder reservoir using a syringe.
4. 4
   Remove the clip and disconnect the brake pipe (A) from the master cylinder. [MT only]

   

5. 5
   Disconnect the brake pipes (A) and (B). Tightening torque: ABS: 12.7 ~ 16.7 N·m N·m; ESP: 18.6 ~ 23 N·m N·m

   

6. 6
   Remove the safety clip and cotter pin.

   

7. 7
   Remove the locking nuts.

   Tightening torque: 16.7 ~ 26 N·m N·m

   

8. 8
   Remove the master cylinder.
9. 9
   Remove the reservoir by loosening the screw.

   

REMEDY

1. 1
   To install, perform the removal procedure in reverse order.
2. 2
   After installation, bleed the brake system. (Refer to Brake System - "Brake Fluid Bleeding") (Refer to Brake System - "ABS Bleeding")