Brake Line Repair Procedures

DEPOSIT

1. 1
   Disconnect the brake fluid level switch connector and remove the reservoir cap.
2. 2
   Drain the brake fluid from the master cylinder reservoir using a syringe.
3. 3
   Remove the wheel and tire.

   Tightening torque: 88.3 ~ 108 N·m

4. 4
   Remove the clip (A), then loosen the flare nut of the hose (B).

   Tightening torque: 12.7 - 16.7 N·m

   (Front)

   

   (Rear)

   

5. 5
   Disconnect the brake hose from the front caliper by loosening the bolt (A).

   

6. 6
   Disconnect the brake hose (A) from the brake caliper by loosening the bolt. [Type with rear disc brakes]

   Tightening torque: 24.5 - 29 N·m

   

Inspection

1. 1
   Make sure the brake hoses are not cracked, kinked or corroded.
2. 2
   Check the brake pipes for cracks, damage and fluid leakage.
3. 3
   Make sure the flare nuts of the brake pipe are not damaged and there is no fluid leakage.
4. 4
   Make sure the brake hose mounting bracket is not cracked or deformed.

REMEDY

1. 1
   To install, perform the removal procedure in reverse order.
2. 2
   After installation, bleed the brake system. (Refer to Brake System - "Brake Fluid Bleeding") (Refer to Brake System - "ABS Bleeding")
3. 3
   Make sure the brake fluid does not leak.