Battery Sensor Repair Procedures

Removal

1. 1
   Turn the ignition OFF and disconnect the negative (-) battery cable. Negative (-) battery terminal nut tightening torque: 7.8–9.8 N·m

   

2. 2
   Disconnect the battery sensor connector (A).
3. 3
   Disconnect the negative (-) battery cable after removing bolt (B), then remove the battery sensor. Battery sensor cable flange mounting bolt (chassis ground): 10.8–13.7 N·m

   

Installation

1. Install in the reverse order of removal.

Battery Sensor Recalibration Procedure

After reconnecting the negative battery cable, the AMS function does not operate until the system stabilizes, approximately 4 hours. If the negative (-) battery cable is disconnected from the battery during repair work on a vehicle equipped with AMS, the battery sensor recalibration procedure must be performed after the repair work is completed.

1. 1
   Turn the ignition switch ON and OFF.
2. 2
   Park the vehicle for approximately 4 hours with the hood closed and all doors closed.