Hyundai Kona Quiz
DCT (Dual Clutch Transmission) System

Input Speed Sensor 2 Repair Procedures

In this manual: DCT (Dual Clutch Transmission) System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Removal

  1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner")
  2. Disconnect the input speed sensor connector (A).
  3. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
  4. Remove the ECM. (Refer to Engine Control System - "ECM")
  5. Remove the clutch actuator. (Refer to Dual Clutch Transmission Control System - "Clutch Actuator")
  6. Remove the input speed sensor (A).

    Tightening Torque: 9.8–11.8 N·m

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.