Hyundai Kona Quiz
DCT (Dual Clutch Transmission) System

Shift Cable Repair Procedures

In this manual: DCT (Dual Clutch Transmission) System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
22steps
~137min
5/5difficulty
1special tools
0102030405014.711N·mlb·ft
Tightening torque found on this page
Done 0 of 22

Removal

  1. Move the shift lever to the "N" position.
  2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner")
  3. Remove the battery and tray. (Refer to Engine Electrical System — "Battery")
  4. Remove the ECM. (Refer to Engine Control System - "ECM")
  5. Remove the shift cable (C) from the cable bracket (B) after loosening the shift cable nut (A).
  6. Remove the floor console assembly. (Refer to Body - "Floor Console".)
  7. Remove the airbag. (Refer to Body - Airbag)
  8. Remove the heater and blower. (Refer to Heating, Ventilation and Air Conditioning — "Heater").
  9. Disconnect the shift cable.
    1. Disconnect the clevis end (B) after removing the lock pin (A).
    2. Unlock the lock and remove the cable connector (C).
  10. Remove the bracket (A) after loosening the nuts (B-2EA).
  11. Remove the shift cable from the vehicle.

Installation

  1. Install the bracket (A) and tighten the nuts (B-2EA).

    Tightening torque: 11.8–14.7 N·m

  2. Install the shift cable (A) and secure the lock pin (B).
  3. Install the shift cable (A) into the cable bracket (B).
  4. Align the hole (C) in the manual control lever with the "N" position hole (D) of the shift lock switch, then insert the shift lock switch guide pin (SST No.: 09480-A3800).
  5. Lightly tighten the nut (E) after connecting the shift cable (B) to the manual control lever.
  6. Lightly push the shift cable (B) in the direction shown by arrow "F" to remove the free play from the shift cable.
  7. Tighten the nut (E) to the specified torque.

    Tightening Torque: 9.8–13.7 N·m

  8. Remove the shift lock switch guide pin (SST No.: 09480-A3800) from the hole.
  9. Install the battery and tray. (Refer to Engine Electrical System — "Battery")
  10. Install the ECM. (Refer to Engine Control System — "ECM")
  11. Install the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner".)

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.