Hyundai Kona Quiz
DCT (Dual Clutch Transmission) System

Shift Lever Repair Procedures

In this manual: DCT (Dual Clutch Transmission) System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
5steps
~30min
2/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Removal

  1. Remove the shift lever handle and boot (A) by pulling them upward.
  2. Remove the floor console assembly. (Refer to Body - "Floor Console".)
  3. Remove the wire harness clip (A).
  4. Remove the shift cable.
    1. Disconnect the clevis end (B) after removing the lock pin (A).
    2. Disconnect the shift cable connector (C) from the shift lever after pressing the lock.
  5. Remove the shift lever assembly (A) after removing the bolts.

    Tightening torque: 8.8–13.7 N·m

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.