Hyundai Kona Quiz
DCT (Dual Clutch Transmission) System

Gear Actuator Assembly Repair Procedures

In this manual: DCT (Dual Clutch Transmission) System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
7steps
~42min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

  1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner")
  2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")
  3. Remove the ECM. (Refer to Engine Control System - "ECM")
  4. Disconnect the wiring after loosening the bolt (A).
  5. Disconnect the gear shift solenoid connector (C).
  6. Disconnect the gear actuator motor connector (D).
  7. Remove the gear actuator assembly after loosening the bolts (A - 2 EA, B - 3 EA). Tightening torque: (A): 9.8–11.8 N·m (B): 19.6–26 N·m

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.