Hyundai Tucson LM Quiz
Body Electrical System

Overhead Console Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 1Engine Mechanical System — 44Engine Electrical System — 45Emission Control System — 24Engine Control System/Fuel System — 93Clutch System — 13Manual Transmission — 18Automatic Transmission — 87Four-Wheel Drive (4WD) System — 26Drive Shaft and Axle — 29Suspension System — 35Steering — 20Restraints — 47Brake System — 36Body (Interior and Exterior) — 53Body Electrical System — 202Heating, Ventilation, and Air Conditioning — 58
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

Remove the overhead console lamp assembly, then check continuity between the terminals. If continuity is not as specified, replace the map lamp switch.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the lamp unit from the overhead console. (Refer to Group BD - "Roof Trim")
  3. Remove the overhead console lamp (B) after disconnecting the panoramic roof switch connector and the lamp connector (A).
  4. When replacing only the bulb, remove the lens cover (C) from the roof without removing the overhead console lamp assembly.

Installation

  1. Install the bulbs and connect the connectors.
  2. Install the overhead console lamp unit.

Test yourself

A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.