Body Electrical System
Troubleshooting
In this manual: Body Electrical System
~2min read
Troubleshooting
| Symptom | Possible Cause | Remedy |
| One lamp does not illuminate (all exterior) |
Bulb burned out | Replace the bulb. |
| Socket, wiring or ground is faulty | Repair as necessary. | |
| Headlamps do not illuminate | Bulb burned out | Replace the bulb. |
| Ignition fuse blown (LOW: 10 A, HIGH: 20 A) | Check for a short circuit and replace the fuse. | |
| Headlamp fuse blown (15 A) | Check for a short circuit and replace the fuse. | |
| Headlamp relay faulty | Check relay | |
| Lighting switch faulty | Check the switch. | |
| Faulty wiring or ground | Repair as necessary. | |
| Tail lamps and license plate lamp do not illuminate | Bulb burned out | Replace the bulb. |
| Tail lamp fuse blown (10 A) | Check for a short circuit and replace the fuse. | |
| Tail lamp relay faulty | Check relay | |
| Lighting switch faulty | Check the switch. | |
| Faulty wiring or ground | Repair as necessary. | |
| Stop lamps do not illuminate | Bulb burned out | Replace the bulb. |
| Stop lamp fuse blown (15 A) | Check for a short circuit and replace the fuse. | |
| Stop lamp switch faulty | Adjust or replace the switch | |
| Faulty wiring or ground | Repair as necessary. | |
| Stop lamps do not turn off | Stop lamp switch faulty | Repair or replace the switch |
| Instrument panel lamps do not illuminate (Tail lamps illuminate) |
Rheostat is faulty | Inspect the rheostat |
| Faulty wiring or ground | Repair as necessary. | |
| Turn signal lamp does not flash on one side | Bulb burned out | Replace the bulb. |
| Turn signal switch is faulty | Check the switch. | |
| Faulty wiring or ground | Repair as necessary. | |
| Turn signal lamps do not illuminate | Bulb burned out | Replace the bulb. |
| Turn signal fuse blown (10A) | Check for a short circuit and replace the fuse. | |
| Flasher unit is faulty | Inspect the flasher unit | |
| Turn signal switch is faulty | Check the switch. | |
| Faulty wiring or ground | Repair as necessary. | |
| Hazard warning lamps do not illuminate | Bulb burned out | Replace the bulb. |
| Hazard lamp fuse blown (15A) | Check for a short circuit and replace the fuse. | |
| Flasher unit is faulty | Inspect the flasher unit | |
| Hazard switch is faulty | Check the switch. | |
| Faulty wiring or ground | Repair as necessary. |
Test yourself
A quick Hyundai Tucson LM quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?